Motorola F4707A, User Manual

Page: 81 / 224

Using the HC700-G
58
Routine Battery Charge
The battery is fully charged after four hours. During the charge, the Status LED inside the Power
Button shows steady red and turns green when charging is completed.
Important: The battery will not charge if the HC700-G is not properly docked in the cradle.
Battery Replacement
When the battery’s capacity is critically low, the HC700-G automatically enters "Critical Low Battery"
state and shuts down all functions (the screen turns off) to preserve the data in its memory. The
HC700-G allows you to replace batteries without losing information stored in its memory. To avoid
losing data stored in the memory, a charged battery must be installed within 30 minutes.
To replace a battery perform the following steps:
1.
Make sure that the HC700-G is powered off (See “Turning Off” on page 28.).
2.
Remove the HC700-G hand-strap.
3.
Press the battery snap on the battery (see Figure 35) and pull away the battery from the HC700-G.
4.
Insert a fresh battery, bottom end first, into the battery compartment.
5.
Carefully, press the battery top downward until it clicks and locks in place.
Do not store the HC700-G for more than two weeks with battery installed. Storing the
HC700-G with battery installed for more than two weeks without charging may damage
the battery.
!
Caution