Motorola F4707A, User Manual

Page: 165 / 224

Accessories
142
Mounting the Cradle
The Cradle can be installed using the four threaded holes on its back side (see Figure 59). Use four
screws to connect AMPS compatible bracket to Vehicle Cradle body. Use four 5 mm diameter screws
to connect bracket to vehicle body. Planning is the key to fast, easy Vehicle Cradle installation.
Before a hole is drilled or a wire is run, inspect the vehicle and determine how and where you intend to
mount the Cradle and accessories. Plan wire and cable runs to provide maximum protection from
pinching, crushing and overheating. Overheating may occur when running wires too close to heat
generating devices.
The installation planning should only be undertaken by persons who are competent and able to ensure
that the complete installation fulfills its regulatory requirements, such as EMC (Electromagnetic Com-
patibility).
Please note that it is the responsibility of the installing party to ensure that the inclusion of mount
accessories and connections to the battery system is according to local standards and is not in violation
of applicable safety specifications.
5 mm diameter screws
Power cable screw
Bracket - cradle
connection screws
FIGURE 62.
Mounting the HC700 Vehicle Cradle
The Vehicle Cradle
should not be
installed within the
vehicle air bags
deployment area. The
Vehicle Cradle installation should
only be performed by a qualified
installation technician. The
Vehicle Cradle must be installed
using the supplied bracket. The
bracket should only be attached to
the rigid parts of the vehicle.
!
WARNING