Monaco SIGNATURE 2001 series, Owner'S Manual

Page: 159 / 327

AC voltage conditions. The meters monitor AC power supplied from either
shore power or the generator.
Generator Switch:
This switch starts and stops the generator.
NOTE: If the auto-gen start system is programmed, the system will
override the generator start/stop switch. The RC7GS remote will then
have to be used to manually start or stop the generator.
Ta n k M e a s u re m e n t :
To measure the level of any holding tank, push the switch on the monitor
panel corresponding to the tank you wish to measure.
NOTE: If the domestic batteries are not at a full state of charge tank
readings will not be accurate.
Calibration:
The monitor panel is calibrated at the factory for accuracy and
should not require adjustment. If the system is displaying incor-
rectly calibration may be necessary.
• Completely fill the tank to be calibrated.
• Locate the three adjustment screws (one for each tank)
behind the monitor panel.
• Using the adjustment tool simultaneously push the button
for the tank and rotate the adjustment screw until a full
tank reading is obtained.
• Repeat the procedure as necessary for the remaining
tanks.
•The water tank sensors are located on the curbside of the
motorhome, at the end of the holding tanks.
Water Systems
---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
S I G N A T U R E
6 • 1 5 9
Test Points on Monitor Panel
Monitor Adjustment Tool.
Tank Sensors
Grey Water
Holding Tank
Black Water
Holding Tank
Fresh Water Tank
Sensor Strips