Monaco SIGNATURE 2001 series, Owner'S Manual

Page: 132 / 327

Changing the Glass in the Screen Door:
• Slide each piece of glass to the hinge side of the screen door.
• On the latch side of the screen door insert a screw driver into the
upper track observing the installed position of the spacer. Pull the
plastic spacer down and out of the track.
• Raise the glass up and out of the bottom track.
• Replace with new glass and reverse the procedure.
NOTE: The slider glass has a spacer on two corners for centering when the glass
is closed.
Adjusting the Screen Door:
1. Loosen the bolts on the hinge side of the screen door. Slots in the
steel hinge allow screen door movement up and down. Adjust the
screen door so it fits properly with the door.
2. Open the entry door and latch the screen to the door. Loosen the
screws on the hinges and adjust hinge so that it fits snug against the
door triim.
NOTE: The Pos-A-Lok linkage arm will damage the screen door seal if the seal
extends beyond the top of the entry door.
To Extend the Slide-Out Room:
• Move the driver seat forward before activating the slide-out room.
• Confirm that there is at least five feet of clearance outside the
motorhome for the slide-out room to extend.
• Ensure the ignition key is in the OFF position.
• The park brake must be applied.
• The storage bay doors under the slide-out must be closed.
• Ensure people, pets and objects are clear of the slide room travel path.
• Locate the slide-out room control switch in the passenger side overhead
compartment above the entry door.
• Press and hold the slide-out room switch in the OUT position. The slide-
out room will move slowly to the OUT position. To continue the room
movement push and hold the switch in.
• Release the slide-out switch when the room is fully extended (a change
in motor sound indicates extension). The slide-out drive motor will not
stop automatically, the switch must be released.
• Level the motorhome with the leveling system.
WARNING: Before operating the slide room ensure people, pets and objects are
clear of the slide room travel path. Move the drivers seat forward. Ensure there is
five or more feet of clear space outside the slide box prior to extending the slide
room. The outside area must be clear of any obstructions which may hinder the
movement of the slide room. Ensure there is sufficient clearance inside the
Equipment
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
S I G N A T U R E
5 • 1 3 2
SLIDE-OUT ROOM
Extending Room
Screen Door
- Changing the Glass
Screen Door
- Adjusting