Monaco SIGNATURE 2001 series, Owner'S Manual

Page: 137 / 327

To Close the Main Awning:
1. Release the ratchet stud of the main arm and lower the awning
to its bottom most position.
2. Release the ratchet stud of the rafter arm and lift the claw out of
the rafter hook.
3. Place the claw casting on the protruding height adjustment stud.
To lock the assembly in a travel position, push the other tube
downward until the ratchet stud snaps closed. Repeat steps 1-3
for the other end of the awning.
4. Face the awning and hold the end of the control strap firmly in
one hand. Push the roller briskly upward with a rolling motion
until you feel the spring take over. Control the speed of closure
by holding the control strap until all but 6 inches of fabric has
rolled up. Release the strap and let the awning roll up freely. This
extra force will help tighten the fabric around the roller to insure
a tight, neat appearance.
5. Lock the awning in place by flipping the Z-Lock lever into the
closed position using the pull rod.
If the Awning Rolls Up Uneven:
Observe if the roll up is even and in line with
the clamps. If not, unroll the awning and give the
roller a slight push toward the direction it should
open. If you wish to have the awning roll-up
more in either direction, spiral the pull strap in
that direction.
NOTE : The strap must be spiraled
around the roller. This prevents a loose
roll and bunching up of the fabric.
Equipment
---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
S I G N A T U R E
5 • 1 3 7