Monaco SIGNATURE 2001 series, Owner'S Manual

Page: 116 / 327

Appliances
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
S I G N A T U R E
4 • 1 1 6
Two comfort controls are used for the HVAC (heating, ventilating
and air conditioning) system. One comfort control is located in the living
room. The living room comfort control will operate the front roof air
conditioner functions and the LP-Gas furnace operation. If the
motorhome is equipped with an Aqua-Hot, the living room comfort con-
trol will operate the dinette and living room heat exchangers.
The other comfort control is located in the bedroom. The bedroom
comfort control will operate the rear roof air conditioner and (if
equipped) the mid roof air conditioner functions. If the motorhome is
equipped with an Aqua-Hot, the bedroom comfort control will operate
the hallway, bathroom and bedroom heat exchangers. The comfort con-
trol uses a liquid crystal display to inform the operator of current mode
status.
Their are six different functions of the HVAC system: Off, Fan, Cool,
Heat Pump and Furnace. These may be selected by repeat pressing of the
MODE button. The roof air conditioner fan speed is controlled by the
FAN button. Three speeds are available: low, medium and high. Fan
speed control applies to the roof air conditioner’s blower speed only. Selecting
the fan speed Auto adjusts the fan speed automatically, depending on tempera-
ture set point and actual temperature in a selected zone. The roof air conditioner
will use all three blower speeds (low, medium or high) when Auto fan is selected
in Cool mode. If operating in Heat Pump mode and Auto Fan is selected only
low or high blower speeds will be used.
The motorhome is divided into three operating Zones: front, middle and rear.
The living room comfort control is Zone One, although this is not displayed. The
bedroom comfort control operates the middle area, which is displayed as Zone
Two. The bedroom area is considered Zone Three; however, it is displayed as
Zone One on the bedroom comfort control. Zone selection is made by pressing
the MODE and FAN buttons simultaneously. The temperature for any HVAC
function is controlled by pressing the UP or DOWN buttons.
NOTE: The Comfort Control must be turned to ON to operate any HVAC
function. Comfort Control modes cannot be mixed. One zone cannot be on
Cool while another zone is set to Furnace.
NOTE: The motorhome will not heat or cool faster by selecting a very high
or very low temperature setting.
Should the comfort control exhibit unusual symptoms or not respond to
commands, it may need to be reset. To reset:
• Press the MODE button. Display backlighting should illuminate.
• Press MODE, UP and DOWN buttons simultaneously five to ten
seconds. The comfort control should return to mode OFF. The
factory default settings of 72° F for Cool and 68° F for Furnace
should be established.
Comfort Control
Reset
WALL
THERMOSTAT
MODE OFF
MODE
FAN
TEMP
UP
ON
OFF
DOWN
ZONE
ZONE 1
D
UO-
T
HERM