Monaco SIGNATURE 2001 series, Owner'S Manual

Page: 134 / 327

To move the slide-out room manually, retract
the motorhome leveling jacks (see “Leveling
Jacks”). Locate the Slide Room hydraulic pump
on the lower left front frame of the chassis. Turn
the T-Handles counterclockwise approximately
six turns each. The T-Handles may turn easily at
first, however, they will become difficult to turn
as the internal springs are compressed. The room
may move slightly as the valves are opened and
internal pressure is released. It will require sever-
al people to manually move the slide-room. Close
the T-handles when the room is fully retracted.
NOTE: The slide-out room is heavy and may require several per-
sons to push it into the retracted position. When the slide-out room
is in the fully retracted position tighten the T-Handles to hold the
room in place.
Manually overriding the bedroom slide-out:
1. Disconnect the battery cables from the battery.
2. Lift up the mattress and base board to gain access to the
slide-out mechanism.
3. The bedroom slide-out motor has a lever on the back side,
rotate the lever counterclockwise about 1/8 of a turn
(looking from the rear of the motor) to release the brake
that locks the room in place. If the motor does not have a
lever, use a 1/2” wrench to remove the four motor mount-
ing bolts. Remove the motor.
4. Use an appropriate wrench (a 3/4” wrench/ratchet or an
adjustable wrench) on the override to move the room in or
out. The override is located on the opposite side of the
slide-out rail from the motor.
5. Once the room is in, apply pressure to the wrench so that
the room is sealed. Return the brake lever to it’s normal
downward position to lock the room in place. Install the
transit bar (if equipped). If the motor does not have a
brake lever, apply pressure to the wrench so that the
room is sealed and install the transit bar (if equipped). If
there is no motor lever and no transit bar, the motor must
be mounted back onto the slide-out system to hold the
room for transport. If the room is not fully retracted, it
will not be sealed from the environment.
6. Take the motorhome to an authorized dealer for service.
Equipment
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
S I G N A T U R E
5 • 1 3 4
Manual Override
-Emergency Procedures
10 Amp
Fuse
Manual Override
- Bedroom Slide-Out
Location of slide motor lever.
Rotate
approx.30°
counterclockwise
to release the
motor brake.
Brake lever.