Mitsubishi A953GOT-LBD-M3-H, Hardware Manual

Page: 73 / 142

Connection to Peripheral Equipment 5
5-1
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
5. Connection to Peripheral Equipment
This section explains connection of the Handy GOT to the peripheral equipment.
5.1 Connection to peripheral equipment for Handy GOT
The figure below shows connection to the peripheral equipment for the Handy GOT.
• Handy GOT
* The PLC card, the external I/O interface unit and the printer interface unit cannot be
connected to the Handy GOT.
Data transfer cable
5.2 Cable connection procedure
1) Connecting the cable to the personal computer
Connect one side of the data transfer cable 1) to the RS-232C interface port of the personal
computer. (Select a proper data transfer cable in accordance with the port shape of the
personal computer while referring to the table above.)
2) Connecting the cable to the Handy GOT
The outline of the method to remove the rear cover is described below. For the details, refer
to section 2.2.4.
a) Remove four screws which fix the rear cover of the Handy GOT.
b) Open the rear cover.
c) Connect the other end of the data transfer cable 1) to the 9-pin D-Sub connector.
FX-232CAB-1 (3m, 9' 10")
AC30R2-9SS
When the RS-232C port of the personal computer is the 9-pin type
F
2
-232CAB-1 (3m, 9' 10")
AC30R2-9P
When the RS-232C port of the personal computer is the 25-pin type
1)
General-purpose personal
computer (screen creation
software)
Screen creation software
for GOT-900 Series
Connect the cable to
the 9-pin D-Sub, RS-
232C connector (for
personal computer)
provided on the rear
face.
1)
*1
2)
.
.
P O W
E R
G R I P
S W
A953 HANDY GOT