Mitsubishi A953GOT-LBD-M3-H, Hardware Manual

Page: 114 / 142

A953 HANDY GOT Connection to PLC by Sharp 11
11-6
2) Used connectors and connector covers
- Connector on the side of the cable dedicated to the GOT
The connector of the cable dedicated to the GOT (F9GT-HCAB-
††
M) has the following
model name. Use a counterpart connector compatible with this connector.
17JE-23250-02 (D8A2)
25-pin D-Sub, male connector manufactured by DDK Ltd. (DDK)
The cable dedicated to the GOT (F9GT-HCAB1-
††
M) is the untied wire type.
- Port on the side of the PLC by Sharp
Use a connector compatible with the PLC by Sharp.
3) Caution on cable preparation
The maximum cable length varies depending on the specifications of the used PLC by
Sharp. For the details, refer to the INSTRUCTION MANUAL of the PLC by Sharp.
However, make sure that the maximum cable length does not exceed the shorter one
between the specifications of the PLC by Sharp and the value shown in the table below.
Remarks
The table below shows the point of contact of the used connectors and connector covers.
Connection destination
PLC CPU
Maximum cable
length (m)
Remarks
PLC by Sharp
6
Total of F9GT-HCAB-3M and cable prepared by user
Total of F9GT-HCAB1-3M and cable prepared by user
When F9GT-HCAB1-10M is cut
Manufacturer Address Phone No.
DDK Ltd. (DDK)
(Daimei-Fujikura Bldg.) 2-11-20, Nishigotanda,
Shinagawa-Ward, Tokyo 141-0031, Japan
(03)3494-6611