Mitsubishi Electric MELSERVO-J2-Super Series, Transition Handbook

Page: 313 / 662

Part 7: Common Reference Material
7 - 74
MR-J2S-_CP_ MR-J4-_A_-RJ
Conversion rule
No. Name Type Target No. Type Target
87 For manufacturer setting Hex
_ _ XX PD23 Hex _ _ XX
The setting value will be converted as shown in
Table 2 (as output).
However, a setting value other than those in
Table 2 will be converted to _ _04.
When conversion of I/O signal assignment is
enabled, this parameter will be converted
according to the control signal connection of the
renewal tool.
When conversion of I/O signal assignment is not
enabled, the initial value will be used.
This parameter can be used with MR
Configurator2 of software version 1.53F or later.
XX _ _ PD26 Hex _ _ XX
The setting value will be converted as shown in
Table 2 (as output).
However, a setting value other than those in
Table 2 will be converted to _ _07.
When conversion of I/O signal assignment is
enabled, this parameter will be converted
according to the control signal connection of the
renewal tool.
When conversion of I/O signal assignment is not
enabled, the initial value will be used.
This parameter can be used with MR
Configurator2 of software version 1.53F or later.
88 For manufacturer setting Hex
_ _ XX PD27 Hex _ _ XX
The setting value will be converted as shown in
Table 2 (as output).
However, a setting value other than those in
Table 2 will be converted to _ _03.
When conversion of I/O signal assignment is
enabled, this parameter will be converted
according to the control signal connection of the
renewal tool.
When conversion of I/O signal assignment is not
enabled, the initial value will be used.
This parameter can be used with MR
Configurator2 of software version 1.53F or later.
XX _ _ PD28 Hex _ _ XX
The setting value will be converted as shown in
Table 2 (as output).
However, a setting value other than those in
Table 2 will be converted to _ _02.
When conversion of I/O signal assignment is
enabled, this parameter will be converted
according to the control signal connection of the
renewal tool.
When conversion of I/O signal assignment is not
enabled, the initial value will be used.
This parameter can be used with MR
Configurator2 of software version 1.53F or later.
- - - - PA21 Hex X _ _ _
3 _ _ _ will be set.
To use the HC/HA series servo motors without
being replaced, refer to (5) in Section 2.3.5.
- - - - PA01
Hex _ _ _ X
_ _ _ 6 will be set.
(Point table method)
Hex _ _ X _ _ _ 0 _ will be set. (Standard control mode)
Hex _ X _ _ _ 0 _ _ will be set.
Hex X _ _ _ 1 _ _ _ will be set.
Hex: hexadecimal parameter; Dec: decimal parameter