5. Base Specifications Parameters
II - 71
#
Items
Details
Setting range (unit)
ext07
(bit1)
Address
specifying fixed
cycle repetition
count (For M
system only)
Specify the address that specifies the fixed cycle
repetition count. (Applicable only to M65 and M66)
0: Address L only
1: Addresses K and L
If addresses K and L are specified simultaneously,
the data at address K is used for operation.
0/1
(Default: 0)
ext07
(bit2)
F-command unit Specify the unit to be used if a thread cutting read
command contains on decimal point. (Applicable
only to M65 and M66)
0: Type 1 (conventional specifications)
F1
→
1 mm/rev, 1 inch/rev
1: Type
2
F1
→
0.01 mm/rev, 0.0001 inch/rev
0/1
(Default: 0)
ext07
(bit3)
G-code group
for unidirectional
positioning (for
M system only)
Specify the G-code group for unidirectional
positioning. (Applicable only to M65 and M66)
0: Unmodal G code (group 00)
1: Modal G code (group 01)
Related parameter: #8209 G60 SHIFT (Set the last
positioning direction and
distance for each axis
applicable when the
unidirectional positioning
command is issued.)
0/1
ext07
(bit4)
Operation by
independent
G40 command
Specify the mode of canceling radius compensation
vector by the independent G40 command.
(Applicable only to M65 and M66) (Default: 0)
0: Type 1 (conventional specifications)
The independent G40 command cancels the
radius compensation vector.
1: Type
2
The radius compensation vector is not
canceled by the independent G40 command
but is canceled by the next move command
for the radius compensation plane.
0/1
(Default: 0)
ext07
(bit5)
Cut start position
(For L system
only)
Specify the position from where cutting begins in a
fixed cycle for compound lathe.
0: Conventional
specifications
The cut start position is determined by the
final shaping program.
1: Extended
specifications
The cut start position is determined from the
cycle start point.
0/1
(Default: 0)
Summary of Contents for MELDAS 60 Series
