Mitsubishi Electric MELDAS 60 Series, Parameter Manual

Page: 138 / 443

5. Base Specifications Parameters
II - 42
# Items Details Setting range (unit)
1128 RstVCI Clear
variables by
resetting Specify how to handle the common variables when
resetting.
0: Common variables do not change after
resetting.
1: The following common variables are cleared by
resetting:
During variable 100 group specifications: #100
to #149 are cleared.
During variable 200 group and 300 group
specifications: #100 to #199 are cleared.
0/1
1129 PwrVCl Clear
variables by
power-ON
Specify how to handle the common variables when the
power is turned ON.
0: The common variables are in the same state as
before turning the power OFF.
1: The following common variables are cleared
when the power is turned ON.
During variable 100 group specifications: #100
to #149 are cleared.
During variable 200 group and 300 group
specifications: #100 to #199 are cleared.
0/1
1130 set_t Display
selected tool
number Specify the tool command value display on the
POSITION screen.
0: T-modal value of program command is
displayed.
1: Tool number sent from PLC is displayed.
0/1
1131
(PR)
Fldcc Feed
forward filter
Parameter to suppress acceleration changes with a
filter when starting acceleration or deceleration
Specify the parameter in bits.
3 0 1 2 5 4 6 7
Feed forward filter
bit1: 7.1 (ms)
bit2: 14.2 (ms)
bit3: 28.4 (ms)
bit4: 56.8 (ms)
bit5: 113.6 (ms)
If bit 1 to bit 5 are all 0
or two or more bits of
bit 1 to bit 5 are 1, 3.5
ms is set up.
1132 CRT CRT
brightness
control This parameter adjusts the brightness of the CRT
display unit.
– 3: Highest luminance (Brightest state)
–3: Lowest luminance (Darkest state)
Adjust this parameter to an appropriate brightness
between –3 and 3.
The EL display unit does not have brightness
adjustment‚ so setting is not required.
–3 to 3