Mitsubishi Electric MELDAS 60 Series, Parameter Manual

Page: 303 / 443

7. Servo Parameters
7.4 Supplement
II - 207
7.4.3 Lost Motion Compensation
When the motor is to rotate in the clockwise direction (looking from the load side) at the command for the +
direction, the command direction is CW. Conversely, when the motor is to rotate in the counterclockwise
direction, the command direction is CCW.
This rotation direction can be set with the CNC machine parameters. Note that the meaning of the ± will differ
for some servo parameters according to this motor rotation direction. The servo parameters affected by
CW/CCW are shown below.
SV016 (LMC1), SV041 (LMC2) (When different values are set for SV016 and SV041)
SV031 (OVS1), SV042 (OVS2) (When different values are set for SV031 and SV042)
<Example> If the lost motion compensation amount is to be changed according to the direction, the
compensation amount at the quadrant changeover point of each arc where the lost motion
compensation is applied will be as shown below according to the command polarity.
CW CCW
A X: SV041 X: SV016
B Y: SV016 Y: SV041
C X: SV016 X: SV041
D Y: SV041 Y: SV016
+X -X
-Y
+Y
The Y axis command
direction changes from
the - to + direction.
The X axis command
direction changes from
the - to + direction.
The X axis command
direction changes from
the + to - direction.
The Y axis command
direction changes from
the + to - direction.
A
B
C
D
(Note) The setting value for the parameter is "0" or "-1", the compensation amount is determined as
shown below.
Setting value
for SV016
(Setting value
for SV031)
Setting value
for SV041
(Setting value
for SV041)
Compensation
amount
in + direction
Compensation
amount
in - direction
0 0 No compensation No compensation
n 0 n n
0 m m m
n m n m
n -1 n No compensation
-1 m No compensation m