Mitsubishi Electric MELDAS 60 Series, Parameter Manual

Page: 119 / 443

5. Base Specifications Parameters
II - 23
5. Base Specifications Parameters
After setting up the parameter (PR) listed in the table, turn OFF the NC power. To validate the parameter,
turn ON the power again.
(SETUP PARAM 1. 1/15)
# Items Details Setting range (unit)
1001
(PR)
SYS_ON System
validation
setup
Specify the existence of the 1st system‚ 2nd system
and PLC axis with 1 or 0. 0: Not used
1: Used
1002
(PR)
axisno Number of
axes
Set No. of axes in each system and the No. of PLC
axes.
Specify 6 as the maximum value for each system
and 4 as that for the PLC axis so that the total of
those values is 6 or less. 0 to 6
1003
(PR)
iunit Input setup
unit
Specify the input setting value for each system and
the PLC axis. The parameter units will follow this
specification.
B: 1
μ
m
C: 0.1
μ
m
D: 0.01
μ
m
1013 axname Axis name Specify each axis’ name address with an alphabetic
character.
Use the characters X‚ Y‚ Z‚ U‚ V‚ W‚ A‚ B or C.
Do not specify the same address in one system.
The same address can be specified for the 1st and
2nd system.
The PLC address does not need to be set. (The axis
name is displayed as 1 and 2.) Axis addresses such as
X, Y, Z, U, V, W, A, B,
and C
1014 incax Increment
command
axis name When specifying the program movement rate’s
absolute or incremental method with an address‚
specify the incremental command axis name
address with an alphabetic character.
The address that can be used is the same as #1013
axname.
Specify an address that is different from that #1013.
Setting is not required if absolute/incremental
specification with addresses is not performed
(#1076 Abslnc = 0).
1015
(PR)
cunit Command
unit
Specify the minimum unit of the program movement
amount.
cunit Movement amount for movement
command 1
0: Follow #1003 iunit
1: 0.0001 mm ( 0.1
μ
m)
10: 0.001 mm ( 1
μ
m)
100: 0.01 mm ( 10
μ
m)
1000: 0.1 mm (100
μ
m)
10000: 1.0 mm
If there is a decimal point in the movement
command‚ the decimal point position will be handled
as 1mm regardless of this setting.
0 #1003 iunit
1 0.1
μ
m
10
1
μ
m
100
10
μ
m
1000 100
μ
m
10000 1 mm