Mitsubishi Electric E80 Series, Maintenance Manual

Page: 171 / 212

M800/M80/E80 Series Maintenance Manual
6 Replacing Each Unit
144 IB-1501273-F
6Replacing Each Unit
Carry out a backup of the whole system before replacement as a precautionary measure.
6.1 Data Backup and Restoration
The following two functions are available for the data backup and restoration: all backup function for files in batch and input/
output function for separate files.
The following devices are available in all backup and restoration:
The master data backup and restoration are used for backing up and restoring the initial state data set by MTB. The built-
in memory is used for the master data backup and restoration regardless of the selected device.
Files to be backed up/restored are as follows:
(*1) These data can be backed up only, cannot be restored.
For the input/output function for separate files, refer to the Instruction Manual.
HD Hard disk (This is not displayed on M800S/M80/E80 Series and non-Windows-based
display unit of M800W/M80W Series.)
Memory card Front-side SD card
DS [M800S/M80/E80] Back-side SD card of the display unit
[M800W/M80W] Control unit-side SD card
USB memory -
Screen display File name Data type
System data SRAM.BIN SRAM data (binary files)
Programs, parameters, R registers and so on
ALL.PRM(*1) Parameters
ASSEMBLY.INF(*1) System configuration
Ladder USERPLC.LAD User PLC program
EIPCONFDATA.BIN EtherNet/IP configuration file
Safety parameters SAFEPARA.BIN Safety parameter (binary file)
Safety ladder 1 SAFEPLC1.LAD Safety PLC program 1
Safety ladder 2 SAFEPLC2.LAD Safety PLC program 2
APLC data APLC.BIN C language module created by user
Custom data - Custom screen data
(Custom screen modules, setting files (Config.ini/cus-
tomdef.ini/customload.txt) and PLC alarm messages)