Product and Safety Information
11
Mitel SMB Controller
syd-0657/2.0 – R6.0 – 09.2018
Operating safety
MiVoice Office 400 communication servers are operated on 115/230 VAC mains
power. Communication servers and all their components (e.g. telephones) will not op-
erate when mains power fails. Interruptions in the power supply will cause the entire
system to restart. A UPS system has to be connected up-circuit to ensure an uninter-
ruptible power source. Up to a specific performance limit a Mitel 470 communication
server can also be powered redundantly using an auxiliary power supply. For more in-
formation please refer to your communication server's system manual.
When the communication server is started for the first time, all the configuration data is
reset. You are advised to backup your configuration data on a regular basis as well as
before and after any changes.
Installation and operating instructions
Before you begin with the installation of the MiVoice Office 400 communication server:
• Check that the delivery is complete and undamaged. Notify your supplier immedi-
ately of any defects; do not install or put into operation any components that may be
defective.
• Check that you have all the relevant user documents at your disposal.
• Configure this product with only the assemblies specified and in the locations stated
in the user documentation.
• During the installation follow the installation instructions for your MiVoice Office 400
product in the sequence that is given and observe to the safety warnings they con-
tain.
The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the
presence of uninsulated dangerous voltage within the product’s enclosure that may be of sufficient magni-
tude to constitute a risk of electric shock.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in the literature accompanying the product
Indicates ESD components. Failure to observe information identified in this way can lead to damage caused
by electrostatic discharge.
The ground symbol within a circle identifies the product to be connected to an external conductor. Connect
this product to earth ground before you make any other connections to the equipment.
