MIMAKI CF2 Series, Operation Manual

Page: 136 / 186

— 4.16 —
EXPAND THE CUTTING AREA [EXPANDS]
The Expand function expands the cutting area.
In case of Seneor equipped model, and not using Mark detect function, able to expand the cutting
area 30mm.
This function only supports S (sensor equipped) model.
• To use the register mark detect function with the sensor equipped model, set to
OFF.
• When using a Y shaft work guide plate, and head B/C is selected , in the case of
expand is set to ON, Y shaft work guide plate interrupt the cut area. To pre-
vent hitting head B/C tool and work guide plate, not to use a work guide or use
a pin.
Expand ON
Work guide
pin
25mm
30mm
16mm
Work guide
plate
Expand OFF
1
Display the LOCAL menu page3.
Press the
PAGE
+ key several times .
2
Select [MODE SET]
3
Display the MODE SET page 6.
Press the
PAGE
+ key several times .
• In the case of no sensor model,
page 6 is not displayed.
[ LOCAL ] 1 / 4
TOOL SELECT ———>
CONDITION ———>
TEST CUT ———>
PAGE
+
[ LOCAL ] 3 / 4
INTERFACE ———>
MODE SET ———>
SELF TEST ———>
< MODE SET > 1 / 6
Z STROKE ∗ 7 mm >
MULTI–PASS ———>
VACUUM ∗ AutoOFF >