MIMAKI CF2 Series, Operation Manual

Page: 77 / 186

— 2.29 —
Tangential Crease Swivel
cutter roller blade
End offset The amount of correction of the position at which O O
cutting ends when the tool goes up.
For heavy-weight materials, the amount of correction
should be increased. This will cause the cutter to
finish cutting at a position that goes beyond the
predetermined cutting end position, thereby allowing
easy cut-out of the work. Adjust the start position
while checking the finished state of products.
Up angle The minimum angle required by the raised tool to O O O
change the direction of cutting (marking). This
reduces the degree by which the tool pries the work.
Ring If minute line segments continue, a rounding O O O
distance distance (R) is provided between each two of the line
segments to add another one.
Press The pressure applied to the tool at the time of O O
correction descending is to be corrected when cutting (marking)
heavy-weight works. The works can be cut without
fail when the tool is lowered by adding a pressure
correction value to the previously-set pressure value.
Press (Y) The pressure applied to the roller/cutter can be O
corrected in terms of Y-axis, to perform marking with
a Y-axis pressure applied separately from an X-axis
pressure. To mark a piece of corrugated fiberboard,
it can be placed with its flutes oriented in the Y-axis
for marking with a lighter pressure applied as
compared with the X-axis.
Setting item Description Pen
Line segment 2
R
R
Added line segment
Line segment 1
Work
Dcrease the
cutting depth Increase the
cutting depth
Cutting end position in terms of data