MIMAKI CF2 Series, Operation Manual

Page: 12 / 186

— x —
A place exposed to direct sunlight
Do not install the device at a place
where the temperature of the cut panel
surface exceeds 60 ° C. The cut panel
can deform or break down.
A place in which temperature and humidity
vary by a great margin
Use the device under the following
environment.
Operating environment:
10 to 35 ° C
35 to 75% (Rh)
A place exposed to direct air blow from air
conditioner., etc
Cutting quality could be adversely
affected.
A plate that is not horizontal
If the plotter is not leveled, the plotter
will fail to give correct results. Also
the tilted plotter can break.
A place that vibrates
The device will fail to give correct
results if installed in a place that
vibrates.
A place filled with dirt, dust or tobacco
smoke
The plotter is a precision machine.
Do not use it in a place that is filled
with dirt and dust.
Near flammable materials
When the blower is used fully open,
the exhaust port temperature becomes
extremely high. Do not place flammable
materials near the blower or in front
of the exhaust port.
CAUTION
Precautions in installation