MIMAKI CF2 Series, Operation Manual

Page: 72 / 186

— 2.24 —
ATTACHING THE WORK HOLDER
The work holder prevents the work from moving up after it is cut.
• The work holder can be used for works of up to 10 mm thick.
The work holder does not support thickness greater than 10 mm.
• When using soft works (sponges, etc.), do not use the work holder. The work
holder is designed to hold works such as corrugated fiberboard.
• When using a work holder, be sure that overall bottom sur-
face is flat against the work.
If bottom surface run off the work edge, in a case cutting
edge of a work, cutter does not down and may not cut cor-
rectly.
1
Remove the fixing screw of unit B.
To loosen the screw, turn it counterclock-
wise.
Work holder