MIMAKI CF2 Series, Operation Manual

Page: 51 / 186

— 2.3 —
MODE SET menu
The following explains functions of the [MODE SET] in the LOCAL menu.
Function Description Reference page
COMMAND Commands are set to the MGL-IIc3. Switching
commands on the plotter side is not possible.
(For the CF2, only MGL-IIC3 is available)
UNIT The unit to be used when indicating numerics on the
LCD is specified.
AUTO VIEW A period of time from the completion of cutting
(plotting) to the start of head retraction is specified.
If a time is specified, the blower automatically
switches off following head retraction.
ONE STROKE To eliminate a portion that remains uncut, unneces-
sary vertical motion of the cutter is omitted to permit
single-stroke cutting.
GDP Resolution is adjusted to the one supported by your
CAD.
ORIGIN A command origin is established that matches your
CAD.
Z STROKE The height of the tool, in its lifted position, from the
surface of a work to the bottom of tool is specified.
OH UNIT A value that is transmitted to the computer in return
to the command for the output of effective area
coordinate of the device.
ROTATE A direction in which data transmitted from applica-
tion software are to be turned by 90 is specified.
COMMAND SW The set values that are rendered effective are speci-
fied either those set on the operation panel or those
set on the personal computer.
PEN ASSIGN Pen numbers included in data are assigned to tools
of the device.
MULTI-PASS The number of times to perform cutting is set when
cutting a work that cannot be cut by performing
cutting once.
VACUUM Setup the validity of the auto-off function.
EXPAND When Mark sensor is not used, expand the cut area
of x-axis up to 30mm
MARK SENSOR Set up the register mark detect setting
P. 1.24
P. 4.11
P. 1.29
P. 4.8
P. 1.29
P. 1.27
P. 4.10
P. 1.26
P. 4.9
P. 1.25
P. 4.2
P. 4.6
P. 1.31
P. 4.16
P. 5.8