MIMAKI CF2 Series, Operation Manual

Page: 113 / 186

— 3.17 —
6
Input a value for each pattern.
For [A], input an adjustment value for
pattern A.
For [B], input an adjustment value for
pattern B.
7
Carry out steps of procedure 4 and 5
in repetition.
Repeat these steps of procedure until a
normal pattern is obtained.
8
Invoke the 2nd page of the ADJUST-
MENT menu.
Press the
PAGE
+ key several times to
call up the menu for the adjustment of
the q angle.
9
Select the pattern for the adjustment.
1, 2
10
To check the θ θθ
θ θ
angle, select the [TEST
PATTERN].
Plot the pattern using the pen, then cut
the pattern with the tangential cutter.
11
Input a value for the [CUTTER θ θθ
θ
θ ].
Increasing a value will rotate the pattern
clockwise.
Decreasing a value will rotate the pat-
tern counterclockwise.
Normal pattern 1 (2)
< ADJ > SWIVEL 1 / 3
A (LNG) ∗∗ . ∗∗ >
B ∗∗ . ∗∗ >
TEST PATTERN ———>
< ADJ > SWIVEL 1 / 3
A (LNG) ∗∗ . ∗∗ >
B ∗∗ . ∗∗ >
TEST PATTERN ———>
< ADJUST > θ 2 / 3
CUTTER θ ∗∗ . ∗∗ >
PATTERN No. ∗ 1 >
TEST PATTERN ———>
< ADJUST > θ 2 / 3
CUTTER θ ∗∗ . ∗∗ >
PATTERN No. ∗ 1 >
TEST PATTERN ———>
< ADJUST > θ 2 / 3
CUTTER θ ∗∗ . ∗∗ >
PATTERN No. ∗ 1 >
TEST PATTERN ———>
F3
+
F1
+
F2
+
F1
+
F2
+
PAGE
+
: Pen
: Cutter