Micromeritics AccuPyc 2 1340, Operator'S Manual

Page: 45 / 158

AccuPyc II 1340 System Commands
Aug 2013 3-11
• Multiple choice prompts contain a fixed set of responses and are followed by a
question mark (?). To select a multiple-choice response, press
CHOICE
until the desired
response is displayed, then press ENTER .
At any time while entering information you may:
• Press SAVE to save the information you entered and return to the Reload prompt.
• Press
Alt + CLEAR
to discard the information you entered and return to the Reload
prompt.
Set Up
Press Alt + 2 to access the set-up function.
At the completion of each set-up, you are returned to the Set-up type? prompt. Choose one of the fol-
lowing options:
• Press SAVE to save the information you entered and return to the Reload prompt.
• Choose another set-up type; do not press SAVE unless you are through entering parameters
and wish to return to the Reload prompt.
• Press Alt + CLEAR to discard the information you entered and return to the Reload prompt.
Analysis (and Calibration) Parameters
This option enables you to specify analysis and calibration parameters. Although the Set-up Type is
shown as Analysis Parameters, these same prompts are used to specify Calibration Parameters. The
Set Up enables you to choose or enter parameters to be used
for analysis, calibration, reporting, and data transmission.
Choices: Analysis Parameters, Report Options,
Calibration Data, Communications, Unit Types
Press CHOICE to display the desired set-up type, then press
ENTER
.
The parameters you enter or choose for each set-up type are
stored and used to control the pycnometer until new ones are
specified. Each
Set Up command is explained in subsequent
sections.
Unit[n] SN1234 10 cm3
Set-up type?
Analysis Parameters