MG ZS11, Owner'S Handbook Manual, Page: 295 / 324

MAINTENANCE
Replacing Front Wiper Blades
1 With the bonnet closed, and within 20 seconds
of switching the vehicle power system to the OFF
position, operate the wiper stalk switch by pressing
down and releasing, the wipers will sweep and stop in
the 'service position' on the windscreen.
2 Lift the wiper arm away from the windscreen.
3 Press the retaining clips at both sides (as shown in
the figure), whilst pulling the wiper blade outward,
to remove the wiper blade from the wiper arm and
discard.
4 Position the fitting of the new wiper blade into the slot
of the wiper arm.
5 Push the wiper blade towards the wiper arm until it is
located embedded with a click been heard.
6 Place the wiper assembly back on the windscreen.
7 To exit the service mode and return the wipers to the
park position, operate the wiper stalk switch again by
pressing down and releasing, alternatively, switch the
vehicle power system to the ON position.
279
6