MG ZS11, Owner'S Handbook Manual, Page: 165 / 324

STARTING & DRIVING
F E
1
2
1 Unfold the remote key.
2 With a flat-bladed tool, insert it below the arrow mark
at the side of the key (A), and pry up the battery cover
carefully until the lock pins are separated (B).
3 Then insert the flat-bladed tool into the illustrated
position (C), and apply pressure in the direction
indicated by the arrow until the tail of the key makes
a gap.
4 Continue to use the flat-bladed tool inserting it into
the end of the key/battery cover (D), slightly pry the
battery cover until the two bayonets at the end of
battery cover are released.
5 Carefully prise off the battery cover (1).
6 Press the front part of button battery using slight force
(E) to remove the battery (2).
7 Position the new battery, ensuring that correct polarity
is maintained (“+” side facing up), slide it forward (F)
ensuring it is fully inserted into the slot.
Note: Make sure the polarity is correct (positive
side upward).
Note: It is recommended to use the CR2032
replacement battery.
8 Refit the cover and press tightly, check the gap around
the cover is even.
9 Insert the remote key into ignition switch to
resynchronise it.
149
4