Metos 4241001, Operating Instructions Manual, Page: 14 / 90

14
• START
P r e s s k e y 1 5 S T A R T t o s t a r t t h e f i r s t
c o o k i n g c y c l e : t h e k e y l i g h t s t a y s o n
steady.
At this point...
the temperature display 6 indicates the
actual oven temperature.
The display 9 indicates “MANUAL”
T h e d i s p l a y 9 i n d i c a t e s t h e c u r r e n t
cycle “1” (Second line, after asterisk).
The time display 7 indicates the time
[ i n f ] , o n r e a c h i n g t h e s e t p r e h e a t
temperature, a cyclic beep will signal it is
time to put the food into the oven.
Open the door and place the food in the
oven. If the core probe is to be used, refer
to “Setting the core probe” and “Hints on
using the core probe”. Close the door, the
cooking program will automatically switch
on with CYCLE 2, the time display 7 will
show the total remaining time till the end
of cooking. The passage from cycle 2 to a
subsequent cycle takes place automatically
and is signalled by a beep.
• END OF COOKING
Five minutes before the end of cooking or
5 °C before the probe temperature it is
reached at the core, the display “7” (time
and core probe temperature) blinks in order
to advise the user in advance. When the
time is up or the set core probe temperature
has been reached, an intermittent beep will
signal that cooking has concluded.
To stop the beeping, simply open the oven
door. Remove the food from the oven,
f o l l o w i n g t h e d i r e c t i o n s g i v e n u n d e r
paragraph 2.7 of “Points to remember”.
I f y o u w a n t t o t u r n c o o k i n g b a c k o n
w i t h t h e c y c l e s i n t h e s e q u e n c e t h a t
has just ended, simply press the START
key without having to make any other
settings.
Displaying and changing saved values
If, during cooking, you want to check or
change the settings of: temperature, cycle
time or core probe, autoclima, on pressing
the corresponding key 10-11-12-13, the
display will blink for 10 sec. indicating the
setting. Use the SCROLLER to make the
new setting which will automatically be
saved at the end of TIME OUT*.
To use the additional functions, see under
the headings referring to the function of the
PLUS key.
Note: Manual programs with one or more
cycles in sequence will automatically be
“DELETED” when switching off with key 1
(OFF).
OPERATIONS
7 • SETTING THE OVEN MANUALLY FOR MANUAL
COOKING WITH UP TO 9 CYCLES IN SEQUENCE
900-----rev00
STARTING THE COOKING PROGRAM