Metos 4241001, Operating Instructions Manual, Page: 11 / 90

11
STARTING THE COOKING PROGRAM
Place the food in the oven. Refer to the
“ P r a c t i c a l A d v i c e ” h e a d i n g f o r m o r e
information.
If the core probe is to be used, refer to
“Setting the core probe” and “Hints on using
the core probe”.
6.5 • START
Press key 15 START to start cooking: the
key light stays on steady.
At this point...
the temperature display 6 indicates the
actual oven temperature.
The time display 7 indicates the time
remaining to complete cooking.
The luminous dot alongside the value
indicates:
blinking = cooking in progress;
permanently alight = cooking suspended.
Note: When igniting the appliance for the
first time each day, the steam generator
discharges the water it contains, activates
the timed steam generator wash, then,
after loading with water, it runs the steam
g e n e r a t o r A U T O M A T I C P R E H E A T I N G .
When starting a program with steam or
combination cooking cycles, the program
i s a c t i v a t e d a u t o m a t i c a l l y a s s o o n a s
t h e s t e a m g e n e r a t o r h a s r e a c h e d t h e
preheating temperature, so the program
will not start if there is no steam. The
message “BOILER COLD” indicates that
the steam generator has not yet reached
the preheating temperature.
6.6 • END OF COOKING
If infinite time has been selected, stop
cooking by pressing key 15 PERMANENT
STOP for 3 seconds.
Five minutes before the end of cooking or
5 °C before the probe temperature it is
reached at the core, the display “7” (time
and core probe temperature) blinks in order
to advise the user in advance. When the
time is up or the set core probe temperature
has been reached, an intermittent beep will
signal that cooking has concluded.
To interrupt the signal, simply open the
oven door. Remove the food from the
oven, following the directions given under
paragraph 2.7 of the “Points to remember”
heading.
If you want to turn on cooking a second
time with the same settings, after putting
t h e f o o d i n t h e o v e n , j u s t p r e s s k e y
1 5 ( S T A R T ) w i t h o u t h a v i n g t o d o t h e
settings again.
Displaying and changing saved values
If, during cooking, you want to check or
change the settings of: temperature, cycle
time or core probe, Clima, on pressing the
corresponding key 10-11-12-13, the display
will blink for 10 sec. indicating the setting.
U s e t h e S C R O L L E R t o m a k e t h e n e w
setting which will automatically be saved at
the end of TIME OUT*.
6 • SETTING THE OVEN MANUALLY FOR “MANUAL” COOKING
900-----rev00
OPERATIONS