SECTION 4
OPERATOR MAINTENANCE
86
Cleaning the Ink Revolver Couplings
1.
First Deprime the system and remove the
Printhead Cartridge.
2.
Moisten a foam swab in distilled water.
3.
Insert the swab into one of the ink channels
and rotate the swab to clean the chamber.
4.
Use a new swab for each of the remaining
ink channels until all 10 openings are clean.
(
5 on each side.
)
Cleaning the Cutter Assembly
The Cutter (Cutter Assembly) is used to trim and cut the media web. During this process, paper dust,
label/media trimmings and debris may accumulate in this area; affecting Cutter performance.
When activated the Cutter Motor drives the Cutter, from one side to the other, with a lot of force and speed.
To avoid personal injury; you must power down the printer before touching the Cutter Assembly.
Cutter Assembly maintenance should only be performed by a qualified/trained person. Please contact your
service representative to obtain training or to have them perform this process for you.
CAUTION
THIS PROCESS MUST BE PERFORMED BY A QUALIFIED/TRAINED PERSON.
WARNING
ALWAYS POWER DOWN THE PRINTER BEFORE PERFORMING ANY MAINTENANCE; TO AVOID
SERIOUS SHOCK OR INJURY.
1.
Turn Off the Printer and disconnect power.
Power-down the Print Engine using the ON/OFF
button, then Turn Off the Main Power Switch and disconnect the power cord from the printer.
2.
Using a vacuum and a pair of tweezers, carefully remove any dust and debris from within and
around the Cutter Assembly [A] area. If needed; the Clamshell can be opened to improve access.
Summary of Contents for MACH X
Page 124: ......
Page 125: ...Copyright 2015 NEOPOST USA...