SECTION 2
INSTALLING THE PRINTER
37
Winder
The Winder is used, in conjunction with the Unwinder, for “Roll to Roll” applications.
Proper alignment of the Unwinder, Printer and Winder is critical to operation of the Printer. Position the
Printer on a sturdy, stable level work surface with enough room to place the Unwinder and Winder at the
entry and exit ends of the printer.
Position the Unwinder:
See
“Position the Unwinder”
on previous page.
Position the Winder:
1.
Align the notch on the Printer Spacer Plate with the corresponding notch on the Winder Base as
shown. When aligned, attach Spacer Plate to Winder Base with two screws included.
2.
Test Alignment.
Once you have completed Roll to Roll Setup; run a job. If web drifting is
observed (web runs to one side), readjust Winder alignment. Loosen the two Spacer Plate
mounting screws. Slide the Winder forward or backward as needed, then tighten the screws.
Summary of Contents for MACH X
Page 124: ......
Page 125: ...Copyright 2015 NEOPOST USA...