Memjet MACH X, Operator'S Manual

Page: 18 / 125

SECTION 2
INSTALLING THE PRINTER
12
SECTION 2 – Installing the Printer
Before using the Printer the following must be done:
•
Choose a location for the Printer (plus the Unwinder and Winder if used)
•
Unpack the Printer (plus the Unwinder and Winder if used)
•
Pull the Transport Tab from the Service Station and remove Shipping Tape
•
Install the Printer/Winder Spacer Plate on Printer (if Winder is used)
•
Plug in the Printer and connect it to the computer
•
Install the Printer Driver
•
Install the Ink Tanks
•
Install the Printhead
•
Align the Printer with the Unwinder and Winder (If used)
•
Connect the Unwinder and Winder to the Printer (If used)
•
Load Labels/Media (Roll or Fanfold) and adjust Unwinder/Winder
Transport Inspection
The printer is shipped in appropriate packaging so that, under normal shipping conditions, it reaches its
destination without damage.
NOTICE: Report damage to the carrier. The carrier is liable for any damage during transport.
Transport and storage should take place under the following conditions:
- At temperatures between -25°C and +50°C (-13 °F to 122 °F).
- At a relative air humidity between 5% and 95%, non-condensing.
- At an atmospheric pressure between 70 kPa and 105 kPa.
Exposure to conditions that are not permissible may lead to damage which is not externally visible.
IMPORTANT Please save the packaging materials for future use! It will be required if you ever need to
ship the printer. Before shipping; please refer to the section titled “Preparing Printer for Transport”.
Tools Needed
•
Knife and scissors to open packaging
•
Carpenters Level (recommend using 18” or longer level)
•
Protective, nitrile powder-free gloves should be worn to avoid getting ink on hands when
removing protective packaging materials from the ink coupling areas, the Ink Tank areas, and
when installing/removing Printhead Cartridge and Ink Tanks.
•
Distilled or de-ionized water
•
Non-abrasive, lint free cloths