SECTION 1
GETTING ACQUAINTED
8
Control Panel Button Function in “Roll to Roll” Mode:
The Control Panel has 3 buttons with LED
indicators.
ON/OFF
– Powers Print Engine Up or Down.
WARNING!
Power-down the printer, using
the ON/OFF button before powering off the
Main Power Switch. If this power-down
process is not followed; loss of settings, poor
image quality and reduced printhead life may result.
LOAD/FEED (PAUSE/RESUME)
•
Press to Load Labels/Media.
Press to initially load media into the Printer.
•
Press and Hold to Feed Media through Printer.
Once the media is loaded; press and hold this
button for, about 6 seconds, to create a leader for the Winder.
Tip
: If this button is held down, it will continue to feed media until you release the button.
•
Press to Pause the Job.
Printer will finish printing the labels/media in progress, then stop and hold.
•
Press to Resume Printing.
Press to continue printing the job after a Pause or feed error (
such as a
media jam or running out of media
).
CUT/EJECT (CANCEL)
•
Press to Cancel a Paused Job and Cut the Media Web.
Once the job is finished or paused;
pressing this button cuts the media and retracts the media web to the start position. A paused job
will also be canceled (cleared from printer and computer).
•
Press and Hold to Cancel a Paused Job, Cut and Eject the Media.
Once the job is finished or
paused; pressing and holding this button, for about 6 seconds, will cut the media web and eject the
media from the printer. The labels/media will need to be rethreaded. A paused job will also be
canceled (cleared from printer and computer).
NOTE:
Cancelled Jobs must be resent from the computer, if you want to resume printing.
Summary of Contents for MACH X
Page 124: ......
Page 125: ...Copyright 2015 NEOPOST USA...