7-2
72RH0-74E
73R0206
After temporarily holding the jack (1) until it
contacts the storage bracket, turn the shaft
(4) approximately 90° to 180° by using jack
handle (3) to securely hold the jack in
place.
The spare tire is stowed under the rear
floor.
To remove the spare tire:
73R0127
1) Remove the cap and use a wheel
wrench to loosen the hook bolt of the
spare tire holder. Then, rotate using the
end of the jack handle.
73R0128
2) Unhook the spare tire holder and lower
it slowly.
3) Remove the tire.
To install the spare tire:
1) Install the spare tire facing up the out-
side of the wheel in the reverse order of
removal.
2) Tighten the spare tire holder hook bolt
securely.
WARNING
After using the tire changing tools,
stow them securely or they can
cause injury if an accident occurs.
CAUTION
The jack should be used only to
change wheels. It is important to read
the jacking instructions in this sec-
tion before attempting to use the
jack.
(1)
(3)
(4)
EXAMPLE
NOTICE
Loose the spare tire holder hook bolt
until you can remove the hook by
yourself. If the bolt is loosen too
much, the hook might off and the
spare tire might drop off to the
ground.
Tighten
Loosen
EXAMPLE
WARNING
Do not drive your vehicle with the
loose spare tire holder hook bolt, oth-
erwise it may come loose or the
spare tire may drop off, which can
result in an accident.
EXAMPLE
