| 40 |
4 Operation
| HCU 40 |
Instructions for Use | 1.0 | EN | 01
Copyright Maquet Cardiopulmonary GmbH
The connections for sensors are located on the underside of the control unit CU.
1
Connect the temperature sensor for the
patient water circuit to the connection "T
ext
" patient water circuit
[1]
.
2
1
2
Connect the temperature sensor for the cardioplegia water circuit to the
connection "T
ext
" cardioplegia circuit
[2]
.
3
Position the sensors according to clinical requirements.
NOTE
Observe the connection requirements when using the (⇨ "Gradient Mode", page 49
).
4.1.5 Securing Set of Slide Rails for Tubing Holder (Optional)
1
Release the three screws of the cover on the right and left side of the HCU 40
.
2
Attach the slide rails
[1]
to the right and
left side of the HCU 40.
1
4.1.6 Opening/Closing Stopcocks
1
Turn the desired stopcock to the vertical
position to open it.
Summary of Contents for HCU 40
Page 1: ...INSTRUCTIONS FOR USE HEATER COOLER UNIT HCU 40...
Page 147: ......
