215585
43
Revision A
$
%
Figure 3.86: Alignment Control
–
Rear Right View
5.
Align hole in cam arm (A) with hole in clevis (B) on the rod
end of the cylinder.
$
%
Figure 3.87: Cam Arm Alignment
6.
Ensure the end of cam arm (A) is parallel with clevis (B) on
the rod end of the cylinder. If adjustment is required, use a
bar to turn the clevis until the clevis is parallel with
cam arm (A).
NOTE:
The rod end of the cylinder will be attached to the
transport casting after the system is primed. For
instructions, refer to
6.2 Priming the Hitch Swing Cylinder,
