215585
40
Revision A
Installing Transport Swing Cylinder
$
Figure 3.77: Transport Swing Cylinder
1.
Remove the shipping bag from the pallet.
2.
Retrieve two clevis pins and two cotter pins from the
shipping bag.
3.
Support transport swing cylinder (A). Cut the straps
securing the cylinder to the pallet.
$
%
&
Figure 3.78: Transport Swing Cylinder
IMPORTANT:
Prime transport swing cylinder (A)
BEFORE
installing it on
the carrier frame.
4.
To prime the cylinder, use a hydraulic power pack or tractor
hydraulics. Extend and retract transport swing cylinder (A)
until all the air has been removed. Extend transport
cylinder (A) to dimension (B) of 142 cm (56 in.)
between center of pins.
NOTE:
If you need to adjust the cylinder length, remove bolt (C)
that secures the clevis end. Rotate the clevis to lengthen or
shorten distance between pins (B). When the cylinder
length is correct, reinstall bolt (C) to secure the clevis end.
$
%
&
Figure 3.79: Transport Swing Cylinder
5.
Install barrel end of transport swing cylinder (A) onto the
carrier frame with clevis pin (B). Secure clevis pin with
cotter pin (C).
