214603
392
Revision A
Servicing the Lift Filter
The lift filter filters the oil from the header and reel lift hydraulic systems before it returns to the oil reservoir. It
should be changed whenever the oil in the hydraulic reservoir is changed.
Refer to the following procedures to change the lift filter:
•
Removing Lift Filter, page 392
•
Installing Lift Filter, page 393
Removing Lift Filter
Change the lift filter at the same time that the hydraulic oil is changed (1500 hours or every two years).
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and
remove the key from the ignition before leaving the operator
’
s seat for any reason.
1.
Stop engine and remove key.
2.
Open the hood. Refer to
5.2.3 Opening Hood (Highest Position), page 286
.
1000437
A
Figure 5.191: Hydraulic System
3.
Locate lift filter (A) below the hydraulic oil reservoir.
4.
Place a container underneath the filter to catch any oil
that may leak.
NOTE:
If replacing the filter between oil changes, apply a
vacuum to the supply tank to prevent the oil from
running out of the filter head when the filter is removed.
5.
Clean around head of the filter to prevent
contamination.
1018691
A
B
C
Figure 5.192: Lift Filter
6.
Unscrew the filter (A) with a filter wrench.
7.
Remove gasket (C) from groove (B) in filter head (A).
Summary of Contents for M205
