214603
352
Revision A
1000276
A
B
Figure 5.116: Battery Terminal Location
3.
Remove red plastic cover (A) from positive cable
clamps.
4.
Remove black plastic cover (B) from negative terminals.
5.
If charging battery in windrower, disconnect
positive
battery cable (A), then connect charger cable to positive
post. Connect charger ground cable to the engine block
last, away from battery.
6.
Charge batteries in accordance with charger
manufacturer
’
s instructions.
7.
Close platform. Refer to
.
Boosting the Batteries
A 12-volt battery can be connected in parallel (+ to +) with the windrower battery. Use heavy-duty battery cables.
CAUTION
•
Gas given off by batteries is explosive. Keep sparks and flames away from batteries.
•
Make last connection and first disconnection at the point furthest away from the batteries.
•
Wear protective eye-wear when using a booster battery.
•
Be sure everyone is clear of machine when starting engine. Start engine from operator
’
s station only.
1.
Open the hood. Refer to
5.2.1 Opening Hood (Lower Position), page 284
.
1007877
A
B
Figure 5.117: Battery Boost Posts
2.
Remove red rubber cover from boost post (A) on
windrower frame.
3.
Attach one end of battery cable to positive (+) terminal
of booster battery, and other end to positive boost
post (A) on windrower frame.
4.
Attach second cable to negative (-) terminal of booster
battery, and then to ground post (B) on
windrower frame.
5.
Turn ignition switch in cab as with normal start up.
6.
After engine starts, disconnect cable from windrower
ground first, and then disconnect the other cables.
7.
Replace rubber cover on boost post (A).
8.
Close the hood. Refer to
Summary of Contents for M205
