MacDon M205, Operator'S Manual

Page: 246 / 514

214603
226
Revision A
1008946
A
Figure 4.124: Ground Speed Lever
CAUTION
Check to be sure all bystanders have cleared the area.
10. Start the engine.
11. Press the HEADER UP switch (A) to raise the header to
maximum height.
12. If one end of the header does NOT fully raise, rephase
the lift cylinders as follows:
a. Press and hold the HEADER UP switch until both
cylinders stop moving.
b. Continue to hold the switch for 3
–
4 seconds.
Cylinders are now phased.
NOTE:
It may be necessary to repeat this procedure if there is air in the system.
1000770
A
B
Figure 4.125: Safety Prop
13. Engage the safety props on both lift cylinders as
follows:
a. Stop engine and remove key from ignition.
b. Pull lever (A) and rotate towards the header to
release and lower safety prop (B) onto the lift
cylinder.
c. Repeat for opposite lift cylinder.
OPERATION