214603
102
Revision A
Activating the Swath Compressor
NOTE:
•
All cab display module images in this procedure apply to an M155 Self-Propelled Windrower. Other M Series
models are similar.
•
CDM5 (version 512 or later) and WCM2 (version 237 or later) are required to operate the swath compressor.
•
The DWA must be disabled in the CDM when setting up the swath compressor.
•
Users can activate and set up the swath compressor via in-cab controls without a header attached to an M205
windrower.
•
Use the following procedure when installing and setting up the swath compressor (MD #C2061).
CAUTION
Check to be sure all bystanders have cleared the area.
1009066
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 3.94: CDM Programming Buttons
1.
Turn ignition key to RUN, or start the engine.
2.
Press PROGRAM (A) and SELECT (C) on cab display
module (CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the
upper line.
•
NO/YES is displayed on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? is displayed on the upper line.
1022629
CXXX
MXXX
NO/YES
SWATH COMPR INSTALL?
B
A
Figure 3.95: Swath Compressor Controls
4.
Press SELECT (B) until SWATH COMPR INSTALL? is
displayed on the upper line.
•
NO/YES is displayed on the lower line.
5.
Press right arrow (A) to select YES. Press SELECT (B).
6.
Press SELECT (B) until CALIBRATE SENSORS is
displayed on upper line. NO/YES is displayed on
lower line.
7.
Press right arrow (A) to select YES. Press SELECT (B).
•
TO CALIBRATE SELECT is displayed on upper line.
•
HEADER HEIGHT is displayed on lower line.
8.
Press right arrow (A) to scroll through choices until
SWATH COMPR HT is displayed. Press SELECT (B).
•
SWATH SENSOR CAL is displayed on upper line.
•
SWATH UP TO START is displayed on lower line.
Summary of Contents for M205
