MacDon M205, Operator'S Manual

Page: 260 / 514

214603
240
Revision A
1000780
B
A
Figure 4.161: Header Support
4. Drive the windrower slowly forward until the windrower
feet (A) enter the header supports (B). Continue driving
slowly forward until the feet engage the supports and
the header nudges forward.
1008948
A
B
Figure 4.162: Ground Speed Lever
5. Use the following ground speed lever functions to
position the center-link hook above the header
attachment pin:
•
HEADER TILT UP (A) to retract center-link
•
HEADER TILT DOWN (B) to extend center-link
6. Stop engine and remove key from ignition.
1008781
A
B
Figure 4.163: Hydraulic Center-Link
7. Push down on rod end of link cylinder (B) until hook
engages and locks onto header pin.
IMPORTANT:
The hook release must be down to enable the self-
locking mechanism. If the release is open (up),
manually push it down after hook engages header pin.
8. Check that center-link (A) is locked onto the header by
pulling upward on rod end (B) of cylinder.
OPERATION