214603
165
Revision A
1000663
A
B
C
Figure 4.8: Operator Controls
2.
Ensure lock (A) at the base of the steering column is
engaged at cab-forward or engine-forward position.
3.
Move ground speed lever (GSL) (B) into N-DETENT.
4.
Turn steering wheel until it locks. It may be possible to
move the steering wheel slightly in the locked position.
IMPORTANT:
Do
NOT
attempt to force the wheel out of locked
position as damage to the traction system may occur.
5.
Fasten seat belt.
6.
Push HEADER DRIVE switch (C) to ensure it is OFF.
CAUTION
Check to be sure all bystanders have cleared the area.
1000665
A
B
Figure 4.9: Operator Console
7.
Set throttle (A) to START position
—
fully back.
8.
Sound horn three times.
9.
Turn ignition key (B) to RUN position. A single loud tone
sounds, engine warning lights illuminate as a self-test,
and cab display module (CDM) displays HEADER
DISENGAGED and IN PARK.
10. Turn ignition key (B) to START position until engine
starts, and then release key. CDM displays
programmed header data for five seconds if attached,
and then returns to previous display.
IMPORTANT:
The machine gauges and instruments provide important information about machine operation and condition.
Familiarize yourself with the gauges and monitor them carefully during start-up operation. Refer to
IMPORTANT:
•
Do
NOT
operate starter for longer than 15 seconds at a time.
•
If engine does not start, wait at least 2 minutes before trying again.
•
After the third 15 second crank attempt, allow solenoid to cool for 10 minutes before further cranking attempts. If
engine still does not start, refer to
6.1 Engine Troubleshooting, page 421
•
Do
NOT
operate engine above 1500 rpm until engine temperature gauge is above 40°C (100°F).
NOTE:
When the engine temperature is below 5°C (40°F), follow the procedure for a normal start. The engine will cycle
through a period where it appears to labor until the engine warms up. The throttle is nonresponsive during this time
as the engine is in WARM UP mode. This mode will last from 30 seconds to 3 minutes depending on the
temperature. After the engine has stabilized and is idling normally, the throttle becomes active.
Summary of Contents for M205
