MacDon M205, Operator'S Manual

Page: 150 / 514

214603
130
Revision A
1009984
CALIBRATING FLOAT
PRESS FLOAT + TO START
C###
X###
C
B
A
Figure 3.158: M205 Header Float Display
4. Press right arrow (B) to select YES. Press SELECT (C).
•
TO CALIBRATE SELECT is displayed in upper line.
5. Press left (A) or right (B) arrow until HEADER FLOAT is
displayed on the lower line. Press SELECT (C).
•
CALIBRATING FLOAT is displayed on the
upper line.
•
PRESS FLOAT + TO START is displayed on the
lower line.
CAUTION
Check to be sure all bystanders have cleared the area.
1009985
CALIBRATING FLOAT
FLOAT ( + ) HOLD
C###
X###
A
Figure 3.159: M205 Positive Header Float
Display
6. Press and hold FLOAT + button (A) on the CDM.
•
CALIBRATING FLOAT is displayed on the
upper line.
•
FLOAT ( + ) HOLD is displayed on the lower line.
NOTE:
The word HOLD will flash during calibration. FLOAT (+)
DONE will display on the lower line once calibration is
complete.
7. Release the FLOAT + button (A).
•
CALIBRATING FLOAT is displayed on the
upper line.
•
FLOAT (
–
) HOLD is displayed on the lower line.
1009986
CALIBRATING FLOAT
FLOAT ( - ) HOLD
C###
X###
A
Figure 3.160: M205 Negative Header Float
Display
8. Press and hold FLOAT
–
button (A) on CDM.
•
CALIBRATING FLOAT is displayed on the
upper line.
•
FLOAT (
–
) HOLD is displayed on the lower line.
NOTE:
The word HOLD will flash during calibration. HDR
FLOAT COMPLETE will display on the lower line once
calibration is complete.
9. Release FLOAT
–
button (A).
•
TO CALIBRATE SELECT is displayed on the
upper line.
•
HEADER FLOAT is displayed on the lower line.
10. Press right arrow to select next header sensor calibration or STOP & EXIT. Press SELECT. Refer to Calibrating
the Header Height Sensor, page 125 or Calibrating the Header Tilt Sensor, page 127 .
11. Press PROGRAM to exit programming mode.
OPERATOR
’
S STATION