57
Siren and output settings
For
configuring the siren/bark and output operation
of the
Output Settings
parameter
group at the
Device Type
. Then the program will load the related parameters.
Here you can define values for the output line nr. #1 only. The IO-expansion settings for the
further 3 outputs (nr. 2-4) will be listed later, at the External IO parameter group.
For controling the output
–
to remotely switch by SMS text message or a voice call/ringing
–
change the
OUTMODE
value to
Arm/disarm
(for the alarm system).
To switching the siren you can add it for the incoming input line alarm events by the
SIRENOUT
parameter (when alerting, the siren will be turned on).
The
SIRENDEL
defines the recovery time for the output (the siren will be turned off
(muted) after this defined interval).
For alarm system
arming or disarming
applying the „
bark”
sound can
enabled
by the
SIRENBARK
parameter.
The output has two peration mode: a mono-stable and a bi-stable. The mode can be
configured by the
OUTHDELx
parameter. It holds on the output until the configured
interval, then it switches off.
When its value is:
0 or not defined: it is in bi-stable mode
1-86400 (seconds)
: it’s in mono
-stable mode.
