43
(regarding the
Selected
coloumn)
–
check the proper selection
–
push the
Write config
button at the bottom of the screen. At the end of the parameter sending, the device is
restarting by using the new settings.
If it is necessary, you can save the configuration to your computer by the
Save file
button
at the right upper side of the screen.
Fo further settings, please check the chapter 5.6.
5.3 GPRS transmitting settings
In this operation mode the
Easy 2
is transmitting to the dispatcher center’s
IP address or to
the remot dispatching software - through GPRS. The further settings are recommended to
check or modify in case of necessary.
Load the factory default .CFG file by the
Browse
button.
GPRS transmitting settings
For the
GPRS settings
choose the
GPRS Settings
parameter group at the
Device Type
.
Then the program will load the related parameters.
Change the
GPRSEN
value to
Enable
, to operate the device as a GPRS transmitter.
At the
SFUNCT
parameter you can define thath the primary or secondary server IP address
will be the first in the signalling sequence.
