30
selected phone numbers. When you will not check this box, the operation is valid for the
complete list - be careful!
When you already had multiple phone numbers in your contact list, then you are attempted to
modifiy them and
Save
to the list and record to the device by the
Write
button.
Deletion of some phone numbers can be performed by the
Select
mark selection and pushing
Delete
contacts
button. The
EasyTerm
will
delete all the marked position from the device
directly! Check the Select mark before usong the Delete contacts button!
When you are attempted to delete only one number from the contact list,
but you wouldn’t like to
search the number from the list, then just fill the number in the empty field and just push the
Remove
button. This will delete the written phone number from the device directly.
Over the recorded phone numbers, now you can manually control the output lines
–
even the gate
opening
–
from this feature at here. You can check the current status of the output(s) at the left side
of the screen and you can control by the buttons, manually.
When the gate opening parameter is enabled
(
Configuration:
Output
settings,
OUTMODE:
Gate
), then at the left side of the
screen you can close the gate by the
OUT
title with the
ON
button, and open by the
OFF
(when the
Easy2
sends the control command to the gate opening system).
When the alarm feature was activated
(
Configuration:
Output
settings,
OUTMODE:
Alarm)
then the armin status
can be checked with the
ARM
ON
/
OFF
statuses and here you can arm the alarm system by the
ON
button
or disarm by the
OFF
button.
Important! Over the manual control, these features can be remotely controlled via SMS
text messages and initiating a voice call (ringing).
4.7 Firmware upload/refresh
When you are attempted to upload a newer software to the
Easy
2
then
choose the
Firmware
update
tab from the
Configuration upload
window
(4).
Before uploading a firmware file, always ensure about the
SW VER
(software version) at left side of
the screent (2) which should be older than the version which are attempted to upload.
The refresh can be performed through the serial port (when it was connected on
Serial
Port
), via TCP IP (when it was connected through
TCP-IP (GPRS)
). The program will
