72
Visible and invisible life signal
The visible life signal means that, when the device will send information to the dispatcher
software only from the life signal outages. When the life signal is visible, then all sent life
signals by the device will be visible in the dispatcher software.
6.6 Voice call notification (ringing)
For an input
trigger
event the assigned phone numbers will be activated (related to the input
lines). The ringing of the active phone numbers will be performed by index number
sequence, regardless of which input has been activated for a specific number.
The ringing is succesfully performed, when the assigned numbers to the related input lines
will be inactivated
–
which means that the further configured numbers will be not notified, as
it is setup by default. (Unless you have specific parameters defined for this.)
When the ringed phone number was also active at the other input line, then the other input
assigned numbers will be also inactivated.
The ringing is successful, when the called number is receiving or rejected the call within 20
seconds. In other case, the device continuous the ringing sequence by the next defined
phone number (if here is further). Forthermore, by a special parameter you can
enable or
disable
the sending of SMS notification about the unsuccesful ringings.
In case of receiving the call/ringing the device will hangs up the call without any delay.
You can
enable
the SMS message notification from the unsuccesful ringing by the
IVSMS
parameter (
disabled
by default).
The device cannot handle a difference between the busy call and rejected call.
The voicemail also means a received call, therefore the notification cannot be receivedin this
case.
The ringing will be also unsuccesful, when the called number is busy during the notification
and the call waiting service is not enabled to the phone.
6.7 Gate opening
In mono-stable operation mode the voice call (ringing) initialising a timing, in bi-stable mode
the output changes its status by affection for the ringing.
