83
9.2 Signing the status and signal strength problems
In the
EasyTerm
, at the
Status window
(2) the
„
disconnected
”
status signs that the device was
disconnected from the serial port and it is not accessible (then reconnect the wire and the device or
restart the
Easy2
). The successfull connection will be notified by the
„
connected
” st
atus.
When the device was restarted or you’ve
removed the powe supply, close the
EasyTerm
application.
When you will adding the power adapter for the device or you’ve restarted it
, and the operation of
the
Easy 2
was prepared, then close the connection in the
Connection window
(1), by the
Close
button and remove the serial connection from the computer side. Then reconnect the cable and push
on the
Open
button.
If you’ve received the
Login Failed
message in the
Terminal window
(3) several times, then repeat
these all above.
In the next possible failure status cases you can found some examples about the operation
malfunction and failure statuses. The figures will help you to identify about the proper situation.
Low signal strenght:
move the antenna to a
different position, wait for 30 seconds and recheck
the status by the
Refresh
button.
No available signal strenght/no antenna
fitted:
recheck that the antenna was mounted
and fitted to the device SMA antenna port and
wait for 30 seconds and recheck the status by the
Refresh
button.
