LumaSMART
®
User Manual
Using the Software
•
60
6.
Verify the settings for the specific model configuration of the LumaSMART and press
Next
. Shown below
is:
•
16 Channel (4 FOT @ 4 Channels each)
•
16 Relay (2 Relay cards @ 8 Relays each)
•
4-20mA/0-1mA Configuration of the installed FOT’s
•
IO Module should always be set to
NO
•
Proper communications COMx number associated with each FOT
•
Serial Port of type should be RS485. Note this references Txd-/Txd+ pins of the Serial Connector –
NOT the Rxd/Txd pins of the dedicated RS232 port (see Section 4.3.4
Optional Communications
Wiring
).
7.
When properly configured, press
Next
.
8.
Verify the setting for the configuration and press
Next
.
9.
The next screen confirms ‘Installation Complete’.
10.
Press
Next
, then
Finish
, and then select
Yes
to restart.
If the update is unsuccessful or to revert to the previous firmware version for any reason, press
Restore
.
