MERLIN LEGEND Communications System Release 7.0
System Programming
555-670-111
Issue 1
April 1999
Programming Procedures
3-550
Automatic Route Selection
3
Console Display/Instructions
Additional Information
PC
12. Continue to enter area code or exchange for another table entry number or go to
Step 13.
Select
Next.
Return to Step 10. The next table is
displayed on Line 1.
13. Save your entry.
Select
Enter.
14. Return to the System Programming menu.
Select
Exit
twice.
Start and Stop Times for Subpatterns
3
Use this procedure to specify the time of day that calls are routed using
Subpattern B routing information.
Subpatterns are used to provide two different routing patterns according to the
time of day. This allows you to take advantage of lower rates that may apply to
some or all lines, or to change restrictions on some facilities during off hours.
The stop time for Subpattern B is the start time for Subpattern A.
Enter the time in 4-digit, 24-hour notation, using leading zeros as necessary.
In Release 6.0 and later systems, if you are setting up ARS to allow local users to
make cost-efficient calls on trunks connected to remote systems, you may wish to
check with the remote system manager to ensure that routing stipulates the most
cost-effective timing based on the rates at the remote location. If the remote
system is in a different time zone from your own, you may need to take this into
consideration as well
Summary: Start and Stop Times for Subpatterns
3
Programmable by
System Manager
Mode
Hybrid/PBX
Idle Condition
Not required
Planning Form
3f, Automatic Route Selection Tables
3g, Automatic Route Selection Default and
Special Numbers Tables
