Linhai ATV 500-D T3 EFI, Service Manual

Page: 30 / 291

CHAPTER 2 MAINTENANCE
LH500ATV-D T3 EFI SERVICE MANUA 19.0
CHAPTER 2 MAINTENANCE PAGE. 2- 17
WHEEL, HUB TORQUE TABLE
Item
ATV500
Front Wheel Nuts 69 Ft.Lbs 96 N.m
Rear Wheel Nuts 69 Ft.Lbs 96 N.m
Front Spindle Nut Refer to FRONT HUB
INSTALLATION
Rear Hub
Retaining Nut
80 Ft.Lbs 110.6 N.m
WHEEL REMOVAL
1. Stop the engine, place the transmission in
gear
And lock the parking brake.
2. Loosen the wheel nuts slightly.
3. Elevate the side of the vehicle by placing
a suitable stand under the footrest frame.
4. Remove the wheel nuts and remove the
wheel.
WHEEL INSTALLATION
1. With the transmission in gear and the
parking Brake locked, place the wheel in
the correct Position on the wheel hub. Be
sure the valve stem is toward the outside
and rotation arrows on the tire point
toward rotation.
2. Attach the wheel nuts and finger tighten
them.
Install as shown at right for front or rear
wheels.
3. Lower the vehicle to the ground.
4. Securely tighten the wheel nuts to the
proper Torque listed in the table above.
On rear wheel nuts, Make sure tapered
end of nut goes into taper on wheel.
ATV500
CAUTION:
If wheels are improperly installed it could
affect Vehicle handling and tire wear.
2.6 WHEELS
Inspect all wheels for runout of damage.
Check wheel nuts and ensure they are tight.
Do not over tighten the wheel nuts.